Please explain the heat dissipation methods for power modules / onboard power supplies.

Is it alright to clean the products?

Is it a problem if the load currents of each output are not equal in ±2 output products with insulated onboard power supplies?

Does the power supply produce any sound?

What do the terms such as EHFP and HFP at the end of the product nameplates mean?

Please explain power loss of power supplies.

Please describe the power consumption (loss).

How much output power (current) can actually be used?

Are there specifications for input surge currents (inrush currents) with DC input power modules / on-board power supplies?

How do I measure the output ripple and noise?

Please provide information on support for CCC standards?

Can I use the AC-DC power source for DC input?

Is the AC-DC power supplies isolated?

How do I calculate the power factor?

What is the definition of the inrush current described in the product specifications?

The EMI characteristics of the power supply differ from the published data.

Are there any instructions concerning the wire to be used?

How does a startup warranty differ from a product warranty?

Some products are listed as "not recommended for new designs". Why is this?

Are products without power factor correction circuits exempt from harmonics regulations?

Is it necessary to control the power supply's static electricity?

What does it mean to comply with the Electrical Appliance and Material Safety Law (Appendix Table 8)?

Can I connect the GNDs of multi-output power supplies in common?

Is there a startup time limit?

What altitude does the power supply support?

How do you calculate the power supply's generated heat?

What causes the input side fuse of the power supply to blow? Also, can I replace the fuse myself?

Please provide the insulation resistance values between input-FG and input-output. Also, explain why the insulation resistance between input-FG and input-output is not specified.

Can a withstand voltage test be conducted without connecting each the input and output sides?

How many crimp terminals can be connected to one terminal block (one stud)?